Jump to content
American Road Magazine
Celebrating our two-lane highways of yesteryear…And the joys of driving them today!

An Original Section Of The Old Cumberland Road


Steve_Colby
 Share

Recommended Posts

In an recent email conversation with Bob Bantz, noted authority on Braddock's Road, I was discussing a group of 1920-30s era SHA maps documenting changes to be made to Braddock Road/SRT 49. Braddock Road is the original route of the Cumberland Road before in was rerouted through the Narrows (1830s). The SHA map included a stone spring culvert which I'll certain was part of the original CR. This area is lodged between the backfill of I-68 and the 1930s and later Braddock Road. Bob examined the area carefully and spoke with local SHA officials. The general conclusion is that Bob has found an undisturbed section of the Cumberland Road dating to 1811-24. This section would not have been part of the 1830s rebuild of the road A search of the area with a metal detector turned up a few wagon nails, a piece of lead and a later coin.

This could well be the only existing 1811-1830s section of road left.

 

Steve

Link to comment
Share on other sites

In an recent email conversation with Bob Bantz, noted authority on Braddock's Road, I was discussing a group of 1920-30s era SHA maps documenting changes to be made to Braddock Road/SRT 49. Braddock Road is the original route of the Cumberland Road before in was rerouted through the Narrows (1830s). The SHA map included a stone spring culvert which I'll certain was part of the original CR. This area is lodged between the backfill of I-68 and the 1930s and later Braddock Road. Bob examined the area carefully and spoke with local SHA officials. The general conclusion is that Bob has found an undisturbed section of the Cumberland Road dating to 1811-24. This section would not have been part of the 1830s rebuild of the road A search of the area with a metal detector turned up a few wagon nails, a piece of lead and a later coin.

This could well be the only existing 1811-1830s section of road left.

 

Steve

 

Steve,

 

Well that was just enough to titillate! B):rolleyes: If the exact location is not to be revealed yet (if that is the intent), how long is it....10 feet, 100 feet, a quarter mile?

 

In any event, that is quite the find, and it must be fun to have contributed to the discovery. Kudos to you and Bob!

 

Dave

 

Keep the Show on the Road!

Link to comment
Share on other sites

The original section of road. (Just down for the old stone culvert.) Adjacent to actor Bill Macys's childhood home.

bantz-road-image1.jpg

 

bantz-road-image2.jpg

 

bantz-road-image3.jpg

 

bantz-road-image4.jpg

 

SHA recently flattened two old railroad crossings (circa 1850s and later) in this area and Bob got these shots showing the 1930s road overlay on the old road.

 

braddock-rd-reno2.jpg

 

braddock-rd-reno4.jpg

 

braddock-rd-reno5.jpg

 

braddock-rd-reno6.jpg

 

braddock-rd-reno10.jpg

 

The stone culvert.

 

east-culvert-bantz1.jpg

 

 

 

Steve

Edited by Steve_Colby
Link to comment
Share on other sites

Steve,

 

Thanks for the terrific photos. Actually the most impressive for me is the one showing the 1930 layers on top the broken stone that must have been the old road. Very impressive proof.

 

I was surprised at how little growth there was in the old roadbed. When do you surmise the road was abandoned? It looks like perhaps the early 1930's (perhaps later), based on the lack of tree trucks, or even saplings in the roadbed.

 

That is one terrific discovery! Keep us posted!

 

Dave

 

Keep the Show on the Road!

Link to comment
Share on other sites

Dave,

I too noticed the lack of growth as well as the new growth on the site. I believe the area must have cleared by the I-68 crews in the 1980s.

 

Steve,

 

Makes sense.

 

What a discovery! If that isn't the holiest of the holy grail, I don't know what is. I get excited way out here on the west coast. I recall in college some discussion of the National Road, or the Cumberland Road and now there is a pristine section to see. I hope no one "reconstructs" or restores it.

 

But now I have a problem. What is left to discover? Fifty years of looking for old roads, and now its been done. :blink:B):) Maybe I'll take up stamp collecting!?

 

Dave

 

Keep the Show on the Road.

Link to comment
Share on other sites

Just to the west of the first culvert is a second. Most of it has been buried and hopefully, preserved. The second photo shows the remains of the retaining wall on the right side of this culvert. Both culverts have short sections of road atop them. Bob's section is to the west of the second culvert.

 

braddock-rd-spring-culvert-middle2.jpg

 

braddock-rd-spring-culvert-middle1.jpg

 

~Steve

Link to comment
Share on other sites

  • 2 weeks later...

Just a thought that popped into my head: Did anyone shine a lantern or spotlight into either culvert, just to see what, if anything (other than an unhappily disturbed skunk or raccoon) might be in there?

 

 

As befitting a spring culvert, there is a wall in the back.

Link to comment
Share on other sites

These photos are beyond amazing. Seeing them makes me want to bail out of work, speed all the way to Maryland, and come see!

 

Do you have GPS coordinates for these locations?

 

-Jim

 

Approx. location (within 50 feet or so)39.64058, -78.81739

Link to comment
Share on other sites

Approx. location (within 50 feet or so)39.64058, -78.81739

 

Steve,

 

Thanks for the coordinates. That helps a lot.

 

Google Earth has an 1897 USGS overlay of that area. You probably have done that already, but if not, you may find it interesting.

 

Dave

 

Keep the Show on the Road!

Link to comment
Share on other sites

Steve,

 

Thanks for the coordinates. That helps a lot.

 

Google Earth has an 1897 USGS overlay of that area. You probably have done that already, but if not, you may find it interesting.

 

Dave

 

Keep the Show on the Road!

 

Dave,

I was unaware of the overlay. I tied to figure out how to access it without success, what do I do?

 

~Steve

Link to comment
Share on other sites

Dave,

I was unaware of the overlay. I tied to figure out how to access it without success, what do I do?

 

~Steve

 

Steve,

 

It has been a couple of years since I implemented the historic map overlay library, so I have forgotten the exact setup details. But you will find them here:

 

http://www.gelib.com/historic-topographic-maps.htm

 

Near the bottom of the page there is a button to download the KML file. You may have to experiment a bit.

 

What you should end up with is a Places entry that lists categories of historic topo overlays. Clicking on the check box will display hundreds of boxes (which are the maps) on your Google Earth map, and clicking on the dot in the center of a rectangle (box) should bring up the map for that area, overlaid on the GE map. Then the slider on the left will allow you to adjust the opacity of the historic map and allow you to see the modern map as well.

 

I use it all the time, to my great satisfaction. I'm sure you will be up and running quickly, but if you encounter a glitch, I will go back through the set up myself and advise how I proceeded. I'm sure you will find it worth the effort.

 

Dave

 

Keep the Show on the Road!

Link to comment
Share on other sites

Dave,

My old brain just has a hard time with this new technology. I went to the page you indicated, and found Map Tech was the provider or maps of my area. Unfortunately, none of the hyperlinks appear in those map listings. I'm still lost.

 

By the way, I'm using Dragon to write this reply.

 

Steve

Link to comment
Share on other sites

Dave,

My old brain just has a hard time with this new technology. I went to the page you indicated, and found Map Tech was the provider or maps of my area. Unfortunately, none of the hyperlinks appear in those map listings. I'm still lost.

 

By the way, I'm using Dragon to write this reply.

 

Steve

 

Steve,

 

I replicated the process.

 

Go to the following site and click on the blue button near the bottom of the page. That will download a KML file.

 

http://www.gelib.com/historic-topographic-maps.htm

 

 

With Google Earth open, double click on the downloaded file (its name is historic-topographic-maps.kml).

 

That should create an entry in your Places list (in the panel on the left of the Google Earth window) named Historic topographic Maps. Clicking on the check box next to that entry will bring up historic topos for much of the country.

 

Go to the area in Maryland you want and select the dot in the middle of the box that overlays that area. That will bring up the topo. The slider in the panel on the left will adjust opacity.

 

I don't know where your mention of Map Tech comes into this.

 

I hope this helps.

 

I'm not using Dragon, but maybe I should. I type at hunt and peck speed. :)

 

Dave

 

Keep the Show on the Road!

Link to comment
Share on other sites

Dave,

I'm still not getting the option of USGS map dates on Google Earth.

 

Steve

 

Steve,

 

I'm not sure what you mean by "dates." Can you be more specific?

 

Edited: Does "Historic Topographical Maps" appear in the left panel under "My Places" in "Places?" If not we need to go back to the KML file process. If it does appear, then click on the round button next to "Historic...."

 

 

Dave

 

Keep the Show on the Road!

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
×
  • Create New...